Not using enough water on the paving, especially in warm weather, dries out the product too quickly before it has been brushed into the joints. Joint-IT Neutral 20KG (For Purchase Only At The Same Time As Paving Pack) Increase quantity for SALE! If you are working by yourself, work on small areas and keep wetting the paving as you joint your paved area. We recommend using Joint-It Premium Seal prior to laying paving if you are using Slate, Black or Blue Limestone or Honed Black Granite.

The lid on each bucket and a tick on the colour indicator on the side of each bucket of Joint-It Simple indicates the colour of the product inside.Slate and Granite paving slabs, even those from the same batch, may absorb water at different rates. As you can see from the illustration below, there is not enough surface area at the bottom of the V joint to hold Joint-It Simple in place. If you are using bevelled paving slabs, the joint must be a minimum width of 3mm at the narrowest point between all of the slabs. Because Porcelain is a smoother stone it doesn’t absorb water to the same degree as other natural stone products. Preparation: Make sure all joints are cleaned out to a minimum depth of 25mm (minimum joint width of 3mm) and clear of any dirt.

Sweeping in the jointing compound means getting the job finished faster and better with a more uniform job that stands the test of time. Again, please take note to keep the paving wet at all times when brushing Joint-It Simple into joints.Make sure all joints, and the area to be jointed, are clear of any dirt, oil, grease and debris before you start the job. Brush away and clean the slabs thoroughly and carefully using a with a fine brush (24″ version is good for this), ensuring all of the excess Joint It is removed. If insufficient water has been used, the slabs may draw the product into the stone causing a temporary colour enhancement. The innovative binding technology in joint it Simple makes this premium jointing compound the cut above the rest.