Clean the area around your Manitowoc ice machine regularly, and clean up any fallen ice or water spills as they occur. Level the ice machine and ensure it sits flat on the floor for optimal performance. Ambient room temperature is too warm

The ice machine will start making ice automatically after the sanitize cycle is done (approximately 35 minutes, or 80 minutes for the S3300 model). A dirty machine can slow down the harvest cycle or impede ice from releasing. Clean and sanitize the ice machine following the instructions in the owner’s manual. The Ice Machine isn’t level The Manitowoc NEO Technician Handbook says that if switches aren’t working properly on the NEO touchpad, a reset and test will need to be performed. Disconnect power to the ice machine to reset the control board. Restore power to the machine about 10 seconds later and test out the switches again. If they still don’t work, run an Ohm test to see if the issue isn’t associated with the control board or wiring. Resetting Safety Limits on NEO Undercounter Machines Please close the front door of the machine, and replace the 2 screws, thoroughly securing the front panel. E11: Refrigeration Fault. The compressor discharge temperature didn’t increase by at least one-degree F and the evaporator temperature.Please note some larger products are delivered to kerb-side (the street outside your home), it is at the drivers discretion if they can deliver the item to another location on the property. The slime and mold also form because the ice-making process is exposed to the air. The air, is filled with many contaminants, including mold spores and bacteria that can lead to a dirty ice machine. If you are unable to work another device on the outlet, the ice machine may have blown a fuse or tripped a circuit breaker. If your specific model ice machine is currently calling for a purge, there should be voltage to the valve. A dump valve is normally closed and will only open when voltage is applied. Manitowoc Ice Machine Not Pumping Water Taking half of the sanitizing solution, fill a spray bottle with it and liberally coat the parts with the solution.

E15: Fan Cycle Control Fault – Low Liquid Line Temperature. If the liquid line temperature drops below 60 degrees Fahrenheit for a period of time exceeding continuously for a minute during the freeze cycle.The wrench light signals the harvest season as well as the freezing cycle. This happens in 1-second intervals after three 35-minutes harvest cycles. If it stops working, this could be due to a number of reasons; Allow the water trough to refill until the water flows over the evaporator. This will take approximately 3 minutes. This machine is able to produce up to 12kg of ice per day and 9 ice cubes per cycle with low noise in the meantime. Plus, these ice cubes are bullet shaped to add an exciting twist to your drinks, perfect for parties.