The base of the pot is covered by a plastic cup that doubles as measuring cup (mine is graded in oz and mL) and I fit a small lighter inside the cup to have my cooking system ready to go. If choosing an alcohol brew kit for day walks, Three Points of the Compass is usually carrying a Toaks burner. The other side of the adapter is a 7/16" UNEF threaded connector – just like the one on the top of a backpacking type gas canister. Mark later reported that the epoxy broke after some time and came up with a more robust (and elegant) solution with a drill press and a couple bits.

If you were to go for instance in winter on Everest at 26000 ft (could you say, that 90% propane can go down to -60F ? I had to file the melted bit at home very patiently with a metal file, to make it smooth and flush with the rest of the plastic base so it would fit inside the cook pot again.Primus ETA spider and Optimus Vega did fine once pre-heated although not surprisingly they only had one setting, high. You are correct that you want to keep the vessel clean, no burnt on food or gunk, including the fins underneath the vessel. A 16oz propane canister weighs 780g when full, about the same as two 8 oz backpacking gas canisters.

The Vaude / Markill Puncture Canister Adaptor for C206 converts the CampinGaz C206 puncture gas canisters to the female Lindal 7/16 NS threaded valve interface. White Coat Investor wrote: ↑ Mon Jan 17, 2022 6:12 pmIf you're by the truck there's no reason to use a jetboil. How about the G-Works, can the center pin turn for that purpose or is the notch only there for the assembly?F. Maybe if you start with a fresh canister, keep it warm, and use it in inverted mode -- but not in standard upright mode. My theory is that as the pre-heat tube on the stove heats up the fuel in that section it rapidly expands and creates a back pressure when running in liquid feed mode.

This is particularly true if you have to fly in for a given trip and cannot take canisters from home. I still had my old Coleman Stove which had a regulator that looked essentially the same as the crap Jetboil part and thought that might be a quick, easy fix. The stainless steel Jetboil Pot Support adapts your Jetboil burner so it can be used with their FluxRing® Fry Pan and FluxRing® Cooking Pot, as well as a wide variety of traditional pots and pans. pot to reduce the overall weight but it still includes a canister stand, base bowl, pourer lid and insulated cozy with a durable handle. That, and the heater tab would have to take a labyrinthic path to the burner — unless sticking it between the cooking cup's heat exchanger fins is enough.

The G-Works adapter is easier to use IMO as the knurled finish makes it easier to hand-tighten than the Kovea's polished hex shape. While the stand is useful when using a standard 20 lb propane tank as the donor we do not carry a tank like that when out and about so we leave the stand at home and just turn our 6 lb aluminum tank upside down and carefully perform the refilling process as needed.