Once you have completed the setup, connect the power cord to the receptacle on the rear of the turntable and connect the other end to a working AC outlet. Then, making certain the tonearm lift control level is in the “down” position, place a record on the turntable and press the start button!

Built-in switchable phono/line pre-amplifier with detachable dual RCA output cable with grounding wire Of course, the Audio Technica phono amplifier is part of the build budget for this turntable and, hence, will be limited in terms of sonic quality. As soon as you can buy yourself a separate, external unit, do so. Internally fitted phono amplifiers also produce electrical noise which hampers sound quality. External models don’t infect a turntable in the same way.

Compare to Similar Products

Carefully place the platter on the turntable’s center spindle, and make certain the platter is fully seated on the spindle. Verdict: Despite suffering from the odd sonic and design issue, the AT-LP3 remains a solid bet for any beginner or budget-level buyer. Install the clear plastic dust cover by placing the two hinges into the slots at the rear of the turntable. Note that the dust cover only opens up to a 45 degree angle, but you may also remove the dust cover if you prefer.

Set the preamp switch on the rear of the turntable to correspond with the device you are connecting to. It’s a fully automatic turntable, which means you don’t even have to lift the needle yourself – a simple button jab will return the tonearm to its starting position. Bass, meanwhile was rather blurry and boomy but it could have been a lot worse. The above-mentioned damping did help in terms of stability which provided a measure of lower frequency control, driving the song steadily along. I feel obligated to start this post by saying I am NOT an audiophile and won’t pretend to be one. I just wanted to post a brief review of my current TT set up since I did not find any info about my TT on here after a brief search. I thought this might help others who are new to the vinyl community. Here’s the story:This new turntable from Audio-Technica is of the same breed, also built in China and just qualifies for sub-budget status by a single pound. Audio Technica understands what it takes to create entry-level products. It grasps what each performance is about, prioritising an entertaining performance ahead of focusing on any particular facet. Install the counterweight, making certain that the stylus force gauge dial is oriented towards the front. As you rotate the counterweight, it will thread onto the tonearm. Indicates whether MUID is transferred to ANID, a cookie used for advertising. Clarity doesn't use ANID and so this is always set to 0. Connects wirelessly to speakers and other devices equipped with Bluetooth wireless technology or to wired audio systems and powered speakers via included dual RCA output cable

A built in phono amplifier is useful, especially for those on a strict budget. An external model will improve sound quality though so, again, if you buy the LP3, put one of your ‘to buy’ list.

AT LP3 offers a full automatic in handling, meaning that the turntable will find the first groove on the record by itself and you will not have to worry if you have left the needle in the groove after listening to the entire side of the record. The tonearm will then lift and return to the stand. With the ease of use, the AT-LP3 also has an interesting look and it will easily fit into any interior design just like the very popular and award-winning AT-LP5 turntable. In sound terms, the built-in phono amplifier offers slightly muffled midrange and an indistinct bass yet remains perfectly usable, especially if cash is short. While holding the platter steady, carefully remove the tape securing the red ribbon to the platter. Then use the ribbon to guide the drive belt (attached to the flip side of the platter) over the brass motor pulley. Make certain the belt is properly seated on the motor pulley so it is riding in the pulley’s groove, and verify that the belt is not twisted.