Flip Flops - Mooilo - P - Black - with Beads, Handmade - Flip Flop - Special Sole Construction - Design, Made in Germany

Product Information

Personalised advertising may be considered a “sale” or “sharing” of information under California and other state privacy laws, and you may have a right to opt out. As with my flip flops, that slack can be folded over and sewn into the project, completely covered up by the bling.

While the piece is still warm, but not too hot to handle, run the thong pieces through the appropriate holes with the melted side DOWN. Since I didn’t sew them I don’t plan on wearing them everywhere, but whenever I do I get tons of compliments!And thinking I didn’t have enough white Perler beads I purchased a bag of SIX THOUSAND white Perler beads to use for this project.

Being a cowgirl kind of girl I seldom wear flip flops but I thought these were so cute I wanted to make some. When you use the glittered beads in your normal projects, you don't really notice the actual flecks of glitter once ironed and fused together - unless they are placed right on the edge of your pattern. As a consumer you may complain about products purchased from us via the online dispute resolution portal of the European Commission, see http://ec.

You might find you need to try and different combination of beads here, depending on the particular sizes you have used. These fun beaded designs are just a little bit smaller than my palm and make really ideal embellishments for cards and papercrafts. There will be “slack” using a wider ribbon, that will not show up as much or if at all as compared with a smaller-width ribbon.

She bought black flip flops and used turquoise ribbon and her beads were turqoise, copper, black and white. The photos for the pink flip flops show what it would look like to use a 1-1/2 inch wide ribbon, where the grey flip flops show what it would be like to use a 1/2-inch wide ribbon. But as I ironed to join my first shoe sole made of nothing but beads I realized something… this is not going to be thick or strong enough to hold the thong straps.One a piece of scrap paper trace the outer edge of your sole and then mark the holes for the thong placement. I tried regular sewing machine thread at first, only to be extremely disappointed in it as it snapped more times that I could remember. I normally push one length of twine through with no problems and then use curved ended tweezers to help push the other piece through. When slicing through the rubber sole try to create a nice straight and even line from the hole to the edge in a way that the cut is as short as it can be so you can also keep the integrity of the sole intact as much as possible.