I have the 3000, which I've had for about 10 years or so. Obviously, it's the old style with the rounded rings. Except for a break during a serious medical issue (not related) it's been on mostly 24/7 for more than a year. Two rings have broken at the hinge (one mended with JB Weld) but the cage remains intact. I have a very active job that involves a lot of in/out on/off vehicles and heavy equipment plus bouncing around on a tractor at home, so it is unknown whether the rings breaking were due to a defect, abuse, or because I'm a 'grower' which puts considerable stress on the ring (or a combination of those). Rings and spacers: This is the most important part of the fitting of a chastity device. The ring and spacer must be tight enough and provide minimal gap to ensure the wearer cannot remove the device voluntarily, yet not be so tight as to constrict blood supply and cause long term damage to the testes and penis. I have used two combinations and both were comfortable. Each cage needs to be assessed differently due to the amount of penile flesh contained within. I found wearing a smaller ring with the CB6000 more comfortable, yet whilst wearing the CB6000S I had to wear one size up. With spacer, I can wear the smallest spacer with each cage. Make sure that you lubricate the base of the ring and underneath the cage where it presses on your testes. If you don’t do this, you could be in for some pain, remembering that your urethra will be rubbing on the bottom of the ring. Too tight a ring will also restrict the flow of urine and has the potential to cause problems. It's basically a small bikini fairing with a high windscreen and combined headlight - aimed at combating wind blast.

She was all in favour, by the way, and I suspect rather looked forward to a spell of peaceful weekend lie-ins. As the CB6000 and CB6000S devices don’t allow full cleaning due to their total encapsulation of the penis shaft and head, I find I need to have the cage removed every 3 or so days to clean it thoroughly. This also gives the penis time to “relax and air” and allows for a health inspection. Whilst extended wear is certainly possible, I found that after almost a week of wear without removal, the device tends to get really smelly and needs to be taken off for cleaning. So how about some health-and-safety advice from an actual board-certified urologist instead? “I’ve never had a patient ask me about using, or admit to using, a male chastity device,” said Stephen H. King, MD, a urologist in Washington State. “And I cannot find a single reference in the medical/urological literature.” I gave my wife the key, not because she’s a sexy dominatrix, but because she’s a trustworthy grownup who always knows where important household items are stored. From it's launch in 1998 through to the end of 1999 the Hornet model remained unchanged. For 2000 Honda introduced some modifications to the Hornet and also introduced the Hornet S, a faired version to the bike. Most die hard Hornet fans prefer the original naked version, but saying that, the faired version still looks OK. You can find further information on the Hornet S by scrolling down.I don't know about the new-style rings, but the hinge of the old style (particularly the rivet) can sometimes get uncomfortable, though I've learned how to minimize that. Having a hinged ring is preferable to not (for me). Many women complain that chastity devices are fun when there is sex involved, such as when I am meeting my date and my husband is caged. It gets into both of our heads and creates a fun dynamic. But what about the rest of the week which is filled with work and commitments? We had some rules to remind ourselves of his role. For instance, I dressed first for work and he remained naked until I left the house. This gave him time to make my coffee, make the bed and do other household chores. The presence of the cage, made this routine a little more lively. He wore the cage to work, the gym, and walking the dog.

The 2000 Hornet has re-mapped ignition timing for a slight power increase and better response througout the rev range. The erection is not completely suppressed and the swelling puts some pressure on my testicles (which appear by themselves grow bigger and more full during the night). Can there be other complications from this pressure? Plastic alternatives are available too, if you’re a puny wimp who doesn’t take genital self-mutilation seriously; a sad little weasel unwilling – or, let’s face it, unable – to put in the hard miles on the highway to self-denial.Once you are in an ideal state and ready to attach the device, treat lubricant as your new best friend! Ideally use a water based lube that won’t interfere with the material of your device (silicone lube should not be used with silicone devices) and apply liberally to your genitals (shaft and testicles), you can also apply a small amount to the inside of the device but be aware you may then need to wear gloves to allow some friction to keep hold of the device during the next steps! Steer clear of any “tingle” or “heat” type novelty lubes and consider what will be best for your long-term comfort. 4. The base ring

Indeed, when I jokingly suggested she swallow (the key), the love of my life put her headphones on and pretended I wasn’t there.This set has 5 original rings with 5 sizes varying from small to large. Together with the clear hard plastic pads of different lengths, this will allow you to personalize the fit depending on how tight you want your testicle to be inserted. Using a short plastic spacer secures the device close to your body, making it much harder for you to get out. If you're wearing a root ring and it feels cramped, you can try wearing it with a larger ring one size and a longer spacer so he or she has more flexibility with movement and can actually grab their nails. into your vagina. It weighs less than a metal cage and is inconspicuous under clothing in public. It has length 2. At 5 inches, your slave will be very narrow and fit small penises or the most experienced slaves. I will embellish on style and discuss visibility under clothing. Both devices can be worn comfortably day to day without really being noticed. The CB6000 has a slightly larger bulge in the pants but to date, I have had no-one make any comments about it. The CB6000S is even more discrete and definitely less noticeable. I wear lycra bathers daily as I find it supports the cage and restricts movement. I was wearing bathers daily long before I got into chastity as I enjoyed the sensation they give and chastity only enhances that. I try to wear at least one piece of lycra, leather or lace (LLL) at all time to remind me of my kinky side.

Material: Made of high-quality stainless steel, manual mirror polishing, smoother and more comfortable. Concentrating on the Original naked Hornet, the differnces between the 1998/9 model and the 2000 model as as follows: The mirrors are now square, which look more stylish at first glance compared to the original round ones, but don't appear to offer as good vision.The CB6000 cage seems more prevalent, at least in my case, to breakage. I put this down to the fact that given the length of the cage, the average penis can expand more and therefore exert more pressure on the whole cage. I have already broken two cages and have a spare one on hand if required. Good looking and with an impressive specification, the Moto Morini Seiemmezzo STR is a convincing and very affordable middleweight naked I am a mid-30s male. After a few months of experimentation, I started wearing a chastity device 24/7 about 2 weeks ago. I am able to handle all activities in the day time very comfortably. However, my nocturnal erections are a bit uncomfortable and I wake up 2 times to adjust the device and take a short walk to let it subside. I have three very specific questions about nocturnal erections and one general question about abstention: