Fireplug FPB Intumescent Fire Bandages have been tested by TRADA to British Standards BS476, part 20, test No. IT360, on 14th May 1993. Two hour insulation and integrity was achieved.

Cable Passthrough System | Complete Fire Protection Ltd Cable Passthrough System | Complete Fire Protection Ltd

The Fireplug Cable Passthrough System is a bespoke transit system for temporary cables, designed to maintain fire compartmentation and acoustic performance. Today as more complex buildings are being built to a higher specification the Fireplug Cable Passthrough System (CPT) has been individually designed and then tailored to suit particular aspects of the changing demands of today’s specifiers. The CPT is a unit that can be used to allow a service that can be described as temporary, such as a T.V. camera cable, to pass through a wall/floor yet still maintain the integrity of the wall/floor as designated. What is meant by integrity is that in a fire situation, you maintain stability and insulation along with acceptable smoke stopping. These points are also collated into designing a practical and sensibly operated system.The brush seal solutions allow reduced airflow while filtering out dust and larger particulate matter. Thermal protection and visual screening are additional benefits. icotek brush plates also protect cables against wear due to sharp edges of the cut-out. The galvanised tube is welded to a half round metal plate (as under) and the bolts to another half round metal plate claiming the PVC pipe inside. The PVC pipe is supplied with a range of bends and joints as standard. One important point is where movement or acoustic joints are crossed by the pipe. Shown under is a typical movement and acoustic joint. Pretty simple question I think, I'm just not sure how to do it. My cabling experience is one marathon weekend of rewiring a server closet for a 4 story building, but we had a lot of help and that was 9 years ago.

VCE 2 Pack Cable Brush Wall Plate Cable Pass Through Insert

The accountable factors of the Cable Passthrough System have undergone the relevant testing at FULMER YARSLEY to British Standard BS476, part 22, test No. J85007/1, on 4th January 1990. Four CPTs were tested in the open position, the test was terminated after 128 minutes. The PVC routing system lends itself perfectly to carry beer lines on the same principle as a temporary cable, only this time a beer line is more likely to be permanent. Depending on the size of beer python a PVC routing can be designed to accept more than one. The minimum and maximum radius of the python is taken into account with access hatches built at strategic intervals, as at every bend for example. The python being more rigid than an ordinary cable is pushed along the routing from each access hatch. Below are diagrams of some examples.

Contact Us

Standards dictate you use the T-568B color coding on the wall plates. All wall plates should be simple straight through, there is no twisting on any of them. This is true for patch panels or not. Patch panels will follow this coding as well.