No joke, this thing throws enough light to illuminate every corner of my 12 x 15 music room at night. The front gain trim control and signal/clip LED allow you to optimise the preamp's gain for a wide range of input sources.

So if you're someone who has a turntable that doesn't have a ground wire, then there's potential that you may not need it with this pre-amp. The DJ PRE II is a low-noise, high quality phono interface that allows for incredible sound reproduction and comes in a rugged housing. I found that the sound became livelier when I set it to the point just before the green light flickered red. it could be a little bit more heavy, but if you use the gain poty very rapidly, then it moves some centimeters.com/audiosciencereview), or upgrading your membership here though Paypal ( https://audiosciencereview. Unit 4 - Carberry Court 28 Queen Elizabeth Avenue, Hillington Park, Glasgow, United Kingdom, G52 4NQ.

Preamps need an absolute minimum of 20dB above their nominal sensitivity, which needs to be in the range of 3.The "DJ" wasn't the model that was the hot item a couple of years ago, and I get a dead URL for it (? Here we have three graphs: one for Pluto and two for DJPRE II with its filter switch to Flat and Low Cut. The issue with overload against frequency is the RIAA equalisation that's applied on the cutting side and the opposite on the replay side. The front gain trim control and signal / clip LED allow you to optimize the preamp's gain for a wide range of input sources. My JLTI Phono on the other hand does sound better, but then it cost almost as much as the entire AVR.