While it’s certainly true that very few typical home hardware setups will support anything like the sorts of data transfer speeds and bandwidths that Cat7(a) Ethernet cabling can, using the highest revision wire you can will still offer potential performance boosts in many basic router-to-device networking scenarios.

The newest revision may well become a viable option for more general use in due course, but currently, it’s not recommended for most scenarios in which a standard Cat7 version would be expected to perform well. Where cables like Cat 5, Cat 5e , Cat 6 , and even Cat 8 are quite typical, however, Cat7 is a little different.Due to how far the connectors stick out we've also had to acquire a specialist patch cabinet which allows the patch panels to be mounted back much further than is normally required for such as Cat 5/6a, and this is worth bearing in mind if you are looking at rolling out new cabling infrastructure. The neck part that is supposed to connect to the shielding is too small and doesn't provide any support and cannot be secured properly. Cat7 and Cat 8 cables manufactured with the same shielding, designed to reduce exterior noise and cross talk. Point is that the people that put this piece together ramble all over the place, then admit reverse compatibility, then say it won't be supported; but it's a cable with no moving parts.

Additionally, many people first bought into Ethernet connectivity fairly early on in the home hub era (around the Cat5 cable revision or earlier), and naturally look to the latest versions when needing to replace or upgrade older cables.You should check that you haven't wasted a lot of money on cabling; the shielding will not function if you connect to a non-compliant NIC. However, since your switch can probably already hit its maximum capabilities over Cat 6 shielded cable, it's safe for them to say it works with Cat 7 cable, because Cat 7 is as good or better than Cat 6 in all respects, so the extra quality is just a bonus.

However, the RJ45 endings I have bought come with rubber seals that are supposed to slip over the cable and thus protect the cable terminators. T 10 Gigabit Ethernet over twisted-pair copper requires ISO/IEC Class E (which maps to ANSI/EIA/TIA Cat 6) or better.Designed to support future 40 Gigabit Ethernet connection standards with frequencies up to 1,000MHz, Cat7A is incredibly capable. VCELINK Shielded Connector provides stable, fast network speed for CAT7/CAT6A data network transmissions. These shielded RJ45’s work with solid and stranded cable with 8 pins (gold plated) and 8 conductors.

First it is stated 'Cat7 is pointless for Ethernet' - then it is stated 'Cat7 has been designed for Gigabit Ethernet over 100m'. Cat7 and Cat7a 10 Gbps Ethernet cabling is widely used across a number of industries demanding high performance networking and data transfer infrastructure.Either standard would be seen as a suitable option for demanding use scenarios, such as high-performance data centre applications.