If you’re handy at all in any way, you most likely have an assortment of screws you’ve collected over the years.

Not all games are necessarily playable with the exact same performance provided by the PS5 console’s internal Ultra-High Speed SSD, even where the M.2 SSD device’s sequential read speed is faster than 5500MB/s. Each screw size is described using two numbers – the ‘M’ number and a number indicating the length of the shank, in mm, so M2 screw dimensions of M2 x8, are 8mm long, measured under the screw head. So there’s a non-zero chance that there might be a screw that could fit an M.2 standoff in your collection.

M.2 screws, a relatively new addition to the menagerie of things that you have to screw into your motherboard. Just make sure you don’t destroy anything by trying to jam in a screw that’s way too big. Tape the M.2 Drive Down Screwing it in is just a precaution to make sure that the drive doesn’t get dislodged if you accidentally bump into your PC or something. Yes, this is a possibility, but one that should be done with utmost care, if you don’t want to loose your data or fry you parts mid-session. Get some actual M.2 screws and do it right. But in the meantime… Look for Old Small Screws in Your Home

So you don’t need to screw them in, but it’s such a simple and easy safety measure, there’s no point not doing it. It’ll hold your drive down just fine, to the point where you don’t even need to bother with the M.2 screws when you do find them. Though the drives might come loose If you move your PC around a lot. Skip the M.2 Screw entirely Is it possible to store a part of game data on console storage and the remaining data on M.2 SSD storage? As the name implies, they’re screws designated to screw in M.2 drives into your motherboard. And they can be a right nuisance at times because they have a tendency to magically disappear when you actually need them.M2 screws are typically used in the manufacture of small items of electrical equipment, laptops, cameras and mobile phones. The “M” designation for metric screws indicates the outer diameter of the screw in millimetres, so for an M2 screw, the outer diameter is 2mm. However, in practice the actual diameter might be between 1.9mm-2mm due to manufacturing tolerances. If you just want to make sure the drive stays where you put it and want something that’s lowkey. This is an option. M.2 Drives don’t really need to be screwed down flat onto the motherboard, they temporarily (!) work perfectly fine just hovering at an angle of 30°.