Learning how to change bath taps is quite a bit different and can be a lot harder! How to Change a Kitchen Tap How to Remove a Kitchen Tap Sometimes it’s virtually impossible to get any tools in properly because of the cupboard or other pipework. If your caravan or motorhome mixer tap has become loose or started leaking then chances are you’ll probably need to replace it. Depending on the make, model and age of your leisure vehicle, replacing this tap could be straightforward or a little more time consuming. In most cases you can either find advice from your manufacturer, parts supplier or online via the wealth of information that has been shared by other caravan or motorhome owners. If you’ve come across this blog then we’ll do our best to share some basic guidance on how to replace a caravan mixer tap and point you towards the mixer tap spares we offer to help you get the job done. How to remove a caravan mixer tap Fit horseshoe rubber and plate over the threaded rods under the sink and screw on the nuts and tighten with a box spanner. Plumbing in a new mixer tap is a fairly simple job and should take between 30 minutes to an hour to install depending on the level of experience of the person installing it. If at any point of the installation you are unsure or require help it is recommended to have a professional plumber on hand that you can call for advice.

In this article, we’ll go through the simple steps of how you can perform this handy task yourself. Mixer taps: what are they? Then tighten the nuts on the threaded bar using a box spanner. A box spanner is great for places where there is less space (such as underneath sinks) and looks like a long open tube with a nut shaped hole at the end. Hoses are pre-fitted to mixer taps. If not, screw the hoses into the tap base carefully, tightening by hand only. Follow the instructions which come with the tap. Feed the mains connection ends through the location hole - be careful with the sharp edges on stainless steel sinks and make sure any seals, gaskets, washers and studs are pre-fitted and located according the instruction’s steps.Open the kitchen tap to let the water out, and open a tap upstairs if you have one. This will release most of the water lying in the pipes. This is the same as changing basin taps, kitchen taps and single lever basin taps, they are all virtually the same underneath.

Once the tap is removed, clean off any residue or matter from the open mains pipe connections under the sink. To make the process as easy as possible for you, we’ve collated all the relevant information you’ll need. See the headings below! Water filter taps. With an in-built water filter, these taps help to filter out excess chlorine and impurities from the water making them ideal as part of a kitchen sink. When looking to replace the mixer tap in your caravan or motorhome kitchen area you’ll probably be wondering how to actually access the tap to remove it. In many makes and models, the best way to do this is by first removing the sink, particularly if you don’t have cupboard access below. The sink will most likely be held in place by a number of screws so the first step is to remove these. You may need to gently use a flathead screwdriver to gently ease the sink away from the worktop and be careful not to lose or damage the rubber seal. The largest of the two holes in the washer is where the feed pipes are screwed in and the smaller hole is for the threaded connection bars.

Pull-out Spray Mixer. With an extendable hose, this tap is perfect for rinsing dishes and food and can be used to control the flow of the water.

There should also be parts included with the new mixer tap that you will need for the installation. These are:Completely removing the nut from the stud will allow the tap to be removed complete with its flexible hoses. Make sure no associated washers or seals are left hanging up. Take care when you withdraw the hose ends, especially on stainless steel sinks where sharp edges can figure. Once the tap has been dropped through the hole and the flat washer or mounting plate place over the threaded bars, it is time to slide the steel washer in place.