I’m no longer hunched over after a two day session and to be honest, night fishing has become much more comfortable. It’s a decent fit in my Trakker Tempest 100T Carp Bivvy too, providing plenty of foot space at the front and storage at the rear. This was another key consideration for me. Easy to transport, although not the most compact

As we’ve already mentioned, it’s a decent length and width too so there has been no compromise there. If you have a small car boot or a tight fit in the shed, you might take a look at the Nash Scope Ops 4 Fold Sleep System as an alternative. We will make every reasonable effort to deliver your products safely and in accordance with any specific delivery instructions that you give us however we will not be liable for any delay, damage or loss as a result of complying with such specific instructions. I guess it's also (one of?) the only chairs that can be used on a bed chair and as a standard chair so with no competition they can chose their price!If this happens to you, just untie the knots and tighten the whole rope section again. – Simple! Why you should trust us PLEASE NOTE: All services are normally delivered within 48hours but this is not guaranteed as we cannot be held responsible for problems beyond our control. Length wise, the Trakker RLX 6 comes in at 206cm, so fine even if you’re over 6 foot tall. In terms of width, you’ve got plenty to play with at 78cm too. It’s no Nash wideboy, but perfect if you’re of average build like myself. recommend that you use recorded or special delivery as we can not be liable for any loss or damage in transit. Overall to summarise the size, you’ll be pleasantly surprised at how large it is considering the light transport weight. Strength & Stability

PLEASE NOTE: (Size restrictions do apply, please see Royal Mail webiste for further information.) All Prices are Inc Vat The RLX6 is still going strong and is still my bedchair of choice. The roped mid section has started to come loose slightly after months of sitting in the middle of the bed during my sessions where I didn’t take a chair. This is quite common with most bedchairs after years of use. Whilst it is not as comfortable as it’s bigger brothers, Trakker have done everything in their power to reduce the weight without compromising on comfort. There are a few chairs out there where the rear legs fold flat. If you take the bungs out of the side bars and carry a couple of steel rods that will extend the side bars just enough to sit across the frame of the bedchair then bobs your uncle. Couple of quid fix to the chair of your choice. Why they made 12" legs and then only made 3" extensions, I don't know why. I doubt you could make your own extensions as they have a Groove in so they must have to fit a stud inside the frame. It was probably designed in a factory environment on a perfectly flat floor on a bedchair without its legs extended.

As this Advanta Endurance Reclining Bedchair Buddy is so lightweight, it also makes the perfect guest chair. This is ideal if you’re joined at the bank by another angler, or a friend or family member. After all, it can sometimes be uncomfortable to maintain a conversation over a brew if one of you is stood and the other is sat. This bedchair buddy gives you an easy way of providing a seat to your bankside guest. It also works perfectly as an alternative to a low chair. This is ideal if you’re somebody who enjoys ultra-mobile angling, as this is an exceptionally lightweight solution to the problem of comfortable bankside seating. I got a Trakker RLX Nano chair as I thought they would be good with being able to use it as a "bedchair buddy" or as a low or guest chair, but, despite bringing it fishing it stays in the car usually.

The second issue, as a low chair, they can be comfortable or uncomfortable depending on how much the ground slopes. And if you use it as a fishing chair etc, then getting out of it in a rush is not easy without rolling out of it and then standing up unless your a gymnast. If you also try to move the chair forward to the edge of the bed to get the legs to reach the ground, that does not work either, it still slopes forewards but you also find that you can feel the side of the bed pressing through the updated seat of the chair, and that to is uncomfortableto even attempt sitting in that position. If you’re looking for superior transport size with the Trakker RLX 6 Bedchair, you’re not going to get it unfortunately. Whilst it is lightweight, it doesn’t fold up any more compact than other beds. The bedchair is 3-fold like most of the other bedchairs available on the market.Now given the style of this bedchair, it only makes sense to start by discussing size and weight. Coming in at just under 7kg, the Trakker RLX 6 bedchair is officially one of the lightest bed chairs available on the market. The reason for this is to maintain the flat profile as much as possible and limit sagging within the middle of the bed (also meaning that less central padding is required). To be honest, I was quite surprised at how comfortable the bedchair is without the elasticated midsection. Don’t let this put you off though. The roped midsection makes up for this and to be honest, any additional padding would only add unnecessary weight. If you’re regularly on the move or like to keep the weight of your gear to a minimum, this should definitely be a consideration for your next carp bedchair.