However, that’s not all. Owatrol Oil can also be used as a paint conditioner for oil-based paints and works in a similar way as Floetrol does in water-based paints. Paint conditioners are in the news, at least within decorator circles, discussing the merits and / or (dis)advantages of adding conditioners to water based and oil based paints – to extend coverage, slow down open times, as well as make for a smoother, more level finish.

Paint Stirrers / Mixers Plastering Tools Surface/Floor Protection Systainers & Cases Tape & Spirit Measure Trays & Kettles Wallpaper Accessories Wet Paint Signs 3M Command 3M Claw Simply wrap the rag around the knife once and slide the putty knife along the surface (such as a door frame). Make sure you do this right away whilst the paint is still wet.On brand new metal surfaces, use Owatrol’s AP 60 instead. If you are looking for a high gloss rusted finish you can also overcoat the surface with Deks Olje D2 high gloss clear oil. Using Owatrol Oil to aid adhesion Unless you are a pro and have many years of experience, we recommend using a high quality angled brush to help you get professional looking results first time. The angle makes it especially easier to get into corners and you can fan out the tip to get a fine line. The best course of action is to remove some of the texture. To do this, take a clean putty knife and hold it at a 45 degree angle to the wall and simply run the blade along the edge of the ceiling. Doing this will scrape away a very small amount of the texture and create a small groove.

As stated earlier this oil can also be used as a paint conditioner. When used as a conditioner this oil will increase wet edge time, improve the flowability of the paint and give greater adhesion, plus unlike other more damaging thinners, this oil will maintain the quality of the paint without affecting its appearance or drying time, meaning you can achieve a more professional paint finish. If you use paint conditioners on high-gloss paint, keep in mind that they could make the finish less shiny. In this case, Christofora says to mix a little water with the conditioner.But that’s still not all! Owatrol Oil has many other purposes and can even be used for jobs such as sealing patio slabs and also allows you to paint directly onto rusted metal when used as a primer.

PaintWell increased its Industrial Paints offering with the acquisition of Promain UK Limited, the preferred UK distributor for many of the world’s leading paint and surface coatings manufacturers. Water and white spirit seem a distant memory these days in our quest for the perfect finish paint. Floetrol, Owatrol, XIM Latex Xtender are favoured, bit of linseed oil maybe… What is the story from your science perspective Add 20-25% per litre of paint. Do not add too much conditioner for vertical surfaces as the technique may sag or vanish. Clean UpIt’s worth explaining that there are several strings to this product’s bow. It can be used as a rust inhibitor, paint conditioner or for impregnating wood, but we used it as instructed by readers in a bid to enhance the look of an original tractor. Unlike damaging paint thinners or water, Floetrol does all this without affecting the inherent qualities of the paint or colour. When used in a paint sprayer, Floetrol allows up to 20% reduction in pressure without affecting the spray pattern or performance and helps to prevent clogging and wear and tear on tips. Technical Information:

If there was one product we were itching to get our hands on, it was this! We’d heard so many good things about Owatrol Oil that we wanted to see if the hype was deserved. It maintains the wet edge for longer allowing you to work with the paint in more difficult conditions. It also significantly reduces brush and roller marks and improves paint adhesion, especially to unstable surfaces, and can help to prevent peeling and blistering. For lightly rusted surfaces use a mixture of 1 part OWATROL® OIL to 2 parts Metal Primer. Do not mix or overcoat OWATROL® OIL with paints containing «hot» solvents ie Xylene or two part coatings.I've got a lot of painting left to do on these cabinets. About twelve feet wide by nine feet high. Need to paint the cabinet interiors, face frames, shelves, and 20 doors. Owatrol Oil leaves a bonding film on all surfaces it is used on which maintains the natural look of the surface but allows enhanced adhesion, making it perfect as a foundation for primers or finishing coats. It gives excellent adhesion including on galvanised steel, aluminium, zinc, wood and more. It allows paint to be applied directly to firm rust and is heat resistant up to +175°C. Using Owatrol Oil as a paint conditioner Mix Owatrol Oil into oil-based paints as a paint conditioner to get several great benefits. Firstly, it gives the paint rust-inhibiting properties and helps prevent rust on painted surfaces (even when rust is already present). Secondly, it also improves the flow and workability of the paint. This means that you can maintain the 'wet edge' for longer, reducing brush and roller marks. Finally, it gives the paint a better viscosity allowing painting work to be carried out in a more extreme cold, hot and windy conditions. Unlike damaging paint thinners, it does all this without altering the inherent qualities or the finish of the paint. Using Owatrol Oil for wood impregnation Another common problem is the paper part of the tape might be very thin and constantly rip come when being removed. Have a damp rag on stand by