I am using a pre-mixed mortar, and the instructions say simply "add water until reaching desired consistency". By the end of my last attempt the mix was so wet that water was leaking out but the mortar was still getting stuck. Ultrascape Cempoint meets the strict and exacting standards of BS 7533, and BS EN 998 for masonry mortar and comes supplied in a 25kg showerproof, paper reinforced bag. The gun is moved steadily along the prepared joints between the paving slabs or brickwork, squeezing the gun to release the mortar into the joints. Manufacturers We are proud to partner with the leading manufacturers in the construction materials industry and be an approved supplier.

Cempoint re-points joints between horizontal and vertical faces on cladding, steps, paving slabs and brickwork with ease.if i use a 'hawk', or plate of some sort, to lift the mortar to the wall surface, and use a little trowel to push the mortar into the joints, would that work ?

One thing to remember when mixing thinsets and grouts-or at least one of the many things- is to do your mixing and then let it sit for about five minutes. d) if i put tape on every brick face, could i just slather mortar mix on the wall and scrape it until it filled the joints ?Anyways, is there a technique for adding water, like add the mortar to the bucket first, then add water, or vice versa ? I use that all the time for grout it just has be the right consistancy to wet and it'll turn white later and won't stay in the joints.

Add the contents of the 25kg bag of UltraScape cempoint and mix between 3-5 minutes to achieve an even smooth mix.Fill the head joints, then put your trowl alongside the wall and fill the bed joints quickly and easily wity your pointing trowel. The durable permanently molded in tip can be easily cut to desired size of opening using a good pair of scissors. Ultrascape Cempoint has a working time at 20°C of 45 minutes, and can accept foot traffic after 12 hours and vehicular traffic after 24 hours. Please note: a small trial should be done to ensure compatibility with the stone/paving being used as Instarmac cannot test all stone/paving types. if things get stuck in the tip always have the grout bucket near you and wiggle and squeeze the tip in the bucket and the packed stuff should come out and clear the tip.

RePoint VE is designed to be installed using a grout bag, mortar pump, or grouting sponge where applicable.

I mix smaller batches and gob it in there, and tool and semi-clean every so often, as it's setting up on the stone. With a workability of 45 minutes and a set time of 6 hours, Cempoint is also resistant to freeze/thaw weather conditions and is shrinkage compensated. This listing is for 56 Bags of Cempoint in Natural – however, Cempoint is available in 9 other colours: Light Brown, Light Grey, Dark Grey, Sandstone, Yorkstone, White, Dark Brown, Brick Red and Black. Pressing the Escape (ESC) button will close the modal and bring you back to where you were on the page.