Assuming it's an RC40 (I wouldn't know, it looks like it could be though) would this kit contain all the bits I'd need? with a bit of thought you should be able to use an rc40 kit to make it fit better, you may also need a bracket at the front on the gearbox housing to hold it up at the front too. sorry i hadn't heard from you and have sold the kit to a neighbour, although i might have some other bobbins/brackets and hangers that might help you. I was very careful to realign, slot, file, bend, adjust all my mounts to take and stress out of the bobbins as far as possible - ie it looks when installed, nice and straight, not angled between top and bottom, not in shear. I did think about adding some fail-safe strapping across the two studs of the bobbin to add some security but it wasn't easy to find suitable components, it would have looked messy and probably wouldn't have worked so well.

really sorry again mate, if your interetsed in the other bits i might have cheap let me know and ill rummage in the shed. The only concern I have is the possibility of the nyloc nut walking off as you can't clamp it down hard, but think this is extremely unlikely. rubber silencer mounting, RGM carries them, I'm sure Norvil, Hemmings, Andover, Burtons Bits they're rather common.The rear silencer doesn't come far enough forward to pick up on the centre mounting bracket neatly (the bracket aligns with the clamp that secures the silencer to the collector). Depending on where you live, the time it may take for your exchanged product to reach you, may vary.

This amount includes seller specified domestic postage charges as well as applicable international postage, dispatch, and other fees. Will usually dispatch within same working day if paid before 13:00 GMT (excludes weekends and holidays).The very rear bobbin type mounting rubber on every mini made until the introduction of a rubber hanger strap in 1992.