Your male connector also has two small lumps/keys then correspond to the two small holes either side of the long slot on the female. The female PH has a wide cut out and two holes at the bottom (2 mm pin spacing), whereas the XH has two slots from the top towards the bottom (2.5 mm pin spacing). The term "JST" is sometimes incorrectly used as a vernacular term meaning any small white electrical connector mounted on PCBs.

department. This allows us to be closer from our French customers and main European decision-makers. This connector is also available in a surface mount configuration. Its housing is made of heat resistant resin so that it is not adversely affected during reflow soldering. Because of its tiny size and ability to be surface mounted, this connector meets the demand for high-density mounting of components inside electronic products. The fully shrouded header has walls on all four sides to prevent improper connection to the mating housing and to prevent the intrusion of flux and other contaminants. JST-SH | Molex Picoblade (1.25mm) | JST-ZH | Molex 2mm | JST-RCY | 1.27mm | AR6400/PKZ3352 | DC | PowerI don’t use these very much but one advantage of them is height. The mated assembly is considerably slimmer than any other type of connector I use. It’s a shame the pitch isn’t 2.54mm – I would use them a lot more otherwise. That said, you can usually jam 2 or 3 (maybe even 4) position headers onto strip board if needed. Example part numbers A majority of JST through-hole headers can't withstand the temperatures required for reflow soldering, because the plastic has a lower melting point since they were designed for wave soldering methods. Some JST surface-mount headers are designed to handle higher temperatures of reflow soldering. [25] Connector confusion on the internet [ edit ]

JST Corporate Profile and History". JST. Archived from the original on 27 November 2016 . Retrieved 13 June 2017.Among our electric components, we can put forward a wide variety of innovative catalog products and crimping tools: FFC/FPC connectors (insertion strength zero, no ZIF), to crimp/crossing, SMT/CMS

surface mounting), insulation displacement (IDC), board to board, board to wire, wire to wire, LED, waterproof, pitch from 0.1 to 13mm, hand tools, semi-automatic presses and applicators for all our Very similar to the above series, however in a dual row configuration. Commonly used in LCD / LVDS applications. GH (1.25mm pitch) a b "List of JST connector series; JST". Archived from the original on 2020-11-12 . Retrieved 2013-08-31.The JST-PH connector is used on many high current micro ESC and LiPo batteries - e.g. the E-flite Blade mCPX helicopter, the Spektrum AR6400LBL receiver and several Parkzone, E-Flite 'UMX' models. For more obscure types, no hand tool is offered, however JST do sell a hand frame (YRS-XXX) for mounting dies for their MKS-L applicator (used in the AP-K2N crimping machine), a very expensive solution, and the only option for production/mission critical applications. Unofficial / Generic See the top left female connector in this photo from Common JST Connector Types - PH (2.0mm pitch):