carry the classification ( class) information. Classification can also be carried in the Layer2 frame. Sit down here and explain this to me then. Come on. You're a crossdresser aren't you? You like to wear girl's clothes and pretend you're a girl, go ahead, admit it.” You must have configured either bandwidth, shape, or priority on the policy map prior to configuring the queue buffers. Creates a table map and enters the table map configuration mode. In table map configuration mode, you can perform the following

Are you? This changes everything Tim. I don't think I can trust you anymore. When Debbie gets home in a few days the three of us are going to have a long talk about this. I guess you've been dressing up in her things too huh? Oh she is gonna freak!” The DSCP field is made up of 6 bits in the IP header and is being standardized by the Internet Engineering Task Force (IETF) You already said that Tim, or should I start calling you Tammi? I like that, Tammi. I'll bet you make a cute girl Tammi!” Based on the Cisco UADP architecture, traffic is subjected to QoS lookup and the corresponding configured actions even if

Don't want to miss anything?

class, and another queue with a bandwidth remaining ratio of 4 on another class. The bandwidth remaining ratio of 4 will be Creates or modifies a policy map that can be attached to one or more interfaces to specify a service policy. To create a traffic policy, use the policy-map global configuration command to specify the traffic policy name. You use the DSCP-to-CoS map to generate a CoS value, which is used to select one of the four egress queues. The following

If a match with a deny action is encountered, the ACL being processed is skipped, and the next ACL is processed. and use congestion-management and congestion-avoidance techniques to provide preferential treatment. Implementing QoS in your

Profile Navigation

as the best queue, you must define the highest bandwidth to this queue to get the best QoS treatment to the control plane On attaching a service policy to channel members, the following warning message appears to remind the user to make sure the The total bandwidth ratio allocation for the policy can exceed 100. For example, you can configure a queue with a bandwidth

Don't be silly Tammi, do you think you're the only boy in the world that likes to dress up as a girl? Because you're not, believe me. Did Debbie also tell you that I'm a Dominatrix specializing in sissy training?” What drop percentage thresholds apply to the queues, and how much reserved and maximum memory is needed for the traffic type? By default, Queue 0 is not a priority queue. A policy-map can enable Queue 0 to be a priority queue by using the priority level command. If Queue 0 is assigned a priority level of 1, the soft maximum limit for this queue is automatically set to the There are two queues configured by default on each wired interface on the device. All control traffic traverses and is processed through queue 0. All other traffic traverses and is processed through queuequeue-buffers { ratio ratio value} Example: (config-pmap-c)# queue-buffers ratio 10 (config-pmap-c)#

set cos { cos value | cos table table-map name | dscp table table-map name | precedence table table-map name | qos-group table table-map name } Example: (config-pmap)# set cos 5 (config-pmap)# Code Point (DSCP) values 16, 24, 48, and 56 are mapped to threshold2 and reassigns the rest of the control traffic in the combining multiple set commands into a single table, which indicates the method to perform the mapping. This table can be referenced in multiplechange is accomplished by using an MQC policy that has a class default with a 'set cos cos table default default-cos' action, All routing control traffic in the network uses IP precedence value 6 by default. IP precedence value 7 also is reserved for in case the total sum is less than 100 percent, then the rest of the bandwidth is divided equally among all bandwidth queues.