Note that color doesn't matter, but I tried to follow a standard even though my 4 wire colors did not match the LED colors). You should be able to light it red, green, or blue (sometimes one color will be missing, or combined with another. If you can make pure red, green, blue then you have the wiring correct. It is easy to short the traces on the LED strip such that red+green are combined. Debug and fix this as soon as you notice it) This is where I power the costume. I leave the power connector attached to the LED strip used for the right leg. This is the hardest solder joint (x4) in the entire suit. You will need to solder your 3-way wire on top of the power connector wires. Plug the AA battery adapter into the LED controller (our connectors have a latch to keep this connection from bouncing loose during the night). The costume is very delicate at this point. Be careful moving it because only your solder joints are holding it together.

LED Stickman Costume : 15 Steps (with Pictures Glowing LED Stickman Costume : 15 Steps (with Pictures

Here is what I was thinking...he is 5’5” so two rolls of 16’ led strips to be safe? I was also thinking a 4 way connector right under the hood to connect the head, torso and arms together. Then a 3 way connector on the pants to connect both legs and a small piece to match up to the torso. The LED strips usually come on a roll and have a 4-pin female connector at each end. Look carefully when you open it because the LED strips also come with one (maybe two) 4-pin male/male connectors. You use these to join strips together, but we will use it to join the LED controller to the LED strip.Don't cut the LED's yet, but plan ahead. We arranged the cutting so that the body segment would have one of the two connectors to power the costume, and the right arm would have another that we could use to power a LED sword we built with LED scraps. Slit the white sheath covering the power wires about 3/8" to allow you room to work and reconnect the power wires if them come disconnected while you solder on top of them. (Be careful and only slit as much as you need because you will clamp this power cable along with the tubing at the right leg joint). Usually if part or all goes dark it means a wire has come "open" (disconnected). You will need to trace the connections to find the problem. If the costume dims or you feel any part getting hot you should unplug the power connection (or remove the batteries). This is very unlikely, but possible so use common sense and be safe. Absolute Highlight】Compared to michael myers mask, Jason's mask, Ghostface mask, skeleton mask, and Spiderman mask. The glow Halloween purge costume definitely makes you the center of attention at the Halloween party and lets you get lots of praise from your friends.

costumes – Glowy Zoey costumes – Glowy Zoey

After I have soldered all 4 wires to the torso I solder the left leg next. Be sure to match the correct traces on the LED strips. (sometimes you can flip the leg ends to make the sequence easier to connect) Shorting between 2 colors will cause them both to light no matter which is selected, but shorting the green to the +12V can damage your controller when you power the LED strips. Carnival World】The mask comes with 3 lighting modes and the gloves come with 6 lighting modes. The most stylish Halloween costumes for adults and kids. You'll be the most unique highlight at the Halloween party.

42 Comments