The analog signals for Laser Power. If Glass Tube is used, this pin is recommended to control the power of the Laser.

The laser machines will be equipped with unique configurations (only for machines on www.cloudraylaser.com) which have high stability and marking efficiency. Maximum Speed: it means the maximum limit of motion speed that this axis can bear. This parameter has something to do with the driving force of motor, the inertia of motion axle and its drive ratio. For example, the typical value is 200~500mm/s. Leetro set ups with Lasercut are available on request for those preferring that arrangement. RDWorks Machine Type: In most cases, the general engraving machine should be selected and other types used for specific purposes. One Key Setting: This is one recommended cutting parameters settings button; it is not a parameter, there are several groups of parameters under this button, which is convenient for selection.

This control system employs single 24 power supply. For a certain margin, it is suggested to select 24V/2A above power. Besides, this system is compatible with 36V power, that is to say, the 36V power of Motion driver can directly be connected to this main power port of this system, but generally it is not analog laser control signal 0 ~ 5V automatic following adjustment, TTL level, 20mA drive capability motor control pulse frequency up to 400KHZ. The Ruida RDC6442S is an upgrade from the previous RDC6442 controller, and it comes with advanced features such as a larger screen display, more memory, and improved software compatibility. It supports multiple software programs such as RDWorks, LaserCut, and LightBurn, which provide users with a user-friendly interface for designing and executing laser jobs. Transmission Mode: generally choose “Belt Stepping Type”, the control algorithm will be changed a little when other types are selected. Now, the next axis is called U, and basically it’s an uncommitted control system which allows you to drive a stepper motor,

All outputs are isolated through the optocoupler, and 500mA current for each, OC gate output, each can directly drive the 6V/24V relay, led lamp, buzzer etc. When it is indicated whether the pulse signal of motor driver is the valid rising edge or the valid falling edge, it will be subject to the pulse signal inputted from the minus end of side OC diode. Squares are rectangles and my circles are ovals - Steps per rotation for your machine must be adjusted for designs to be properly sized. Each machine and rotary is different. Below are steps to help calculate steps per rotation.

Be the First to Share

When work is idle or finished, all keys can be pushed, users can select a file to run, set some parameters, preview to a select file etc. But, when work is running or paused, some keys will not respond when they are pushed. Speed Setting