Start by measuring the diameter of the screw’s shaft so you can install a drill bit that’s the same size. As the wood and putty absorb the color, you won’t be able to see the area where you put the screw anymore.

How to Countersink a Screw | The Art of Manliness How to Countersink a Screw | The Art of Manliness

A fluted countersink cutter has a wider base that comes to a point and contains multiple cutting edges so you can make larger holes for the screw’s head. Pick a countersink cutter that has an 82-degree taper since it’s the most common angle on the bottom of the screw’s head. Don’t force the countersink cutter into the wood since you could make the hole too deep or damage the bit. Instead of using a drill bit that both drills the pilot hole and creates a countersink divot, you can opt to make a pilot hole with a regular drill bit and then swap your bit for a countersink drill bit to create the countersink. Tighten the jaws on the clamp to secure the piece of wood so it doesn’t rotate or shift while you’re trying to drill into it.In this case, 100% of readers who voted found the article helpful, earning it our reader-approved status. Suitable for domestic or commercial use, they are made from a highly corrosion resistant stainless steel that is stain proof and easy to clean. jpg","smallWidth":460,"smallHeight":345,"bigWidth":728,"bigHeight":546,"licensing":"