remove the footbeds and let footwear dry slowly and thoroughly in a ventilated, dry and shady place. A further possibility is that mountain boots are made with a leather lining. In this case (fig.6) it is advisable to clean the lining with a damp cloth, let it dry and then apply a light layer of Hydrobloc® Cream or Spray which nourishes the leather keeping it soft and supple. Use the boots only after letting them rest for a few hours. They offer superb comfort, but these linings must be treated at regular intervals to maintain their characteristics, as the acidity of perspiration may damage or alter them. For this reason, you should regularly clean the leather linings with a warm damp cloth, allow to thoroughly dry, and then apply a thin coat Hydrobloc® Proofing Cream or Hydrobloc® Conditioning Spray, which will nourish the leather, keeping it soft and supple. Please note that the warranty will become invalid if the footwear is exposed to this kind of heat sources. Allow the footwear to dry in a fresh and well-ventilated room. It is very important to put them to dry immediately: excessive humidity inside the boot (including sweat) may cause the proliferation of moulds and bacteria.

FOR FOOTWEAR WITH LEATHER LININGS): clean with a warm, damp cloth and allow to thoroughly dry before applying a thin coat of Hydrobloc® Proofing Cream or Hydrobloc® Conditioning Spray. This will maintain the leather lining soft and supple. Leave to dry for a few hours before using the footwear again.The anatomic footbeds supplied with your footwear should be regularly cleaned, and replaced with genuine Zamberlan® footbeds every six months or at least once a year. The first thing to do, before starting to clean your Zamberlan boots, is to remove the laces (fig.1). At this point we can start: the trekking boots must be washed under a jet of cold water (fig.2). If necessary, when they are very dirty, it is possible to use a gentle or neutral soap to make cleaning easier.

Remove odours: to combat bad and unpleasant odours of mountain boots, the secret is to use talcum powder or sodium bicarbonate. Do be careful not to do it too often and remember that a small amount is sufficient.This means taking care of the upper to prevent it from getting ruined and to extend its durability over time

It is possible to use laces that are not produced by Zamberlan as long as they meet GORE-TEXrequirements to guarantee waterproofness. It is a sensible precaution to carry a spare set at all times, especially when walking in remote areas.Leather lining: these types of linings offer a special comfort, but must be treated regularly to maintain their characteristics. Sweat from the feet can in fact damage or modify the acidity. For this reason, we recommend cleaning the lining with a warm and damp cloth, then letting it dry. Finally apply a thin layer of Hydrobloc® Zamberlan® cream or spray. The correct care of your footwear depends on the materials used to manufacture it; the main purpose of any treatment is to “nourish the leather” and enhance its water-proofing characteristics. The frequency, instead, depends on the condition and frequency of use of the footwear. We recommend lighter and more frequent applications rather than occasional and abundant. Moreover, we recommend treating your footwear before putting it away for long periods of time to prevent the leather from drying. IMPORTANT: when using products other than the Hydrobloc® Zamberlan® treatment, it is important to remember that such products must meet the requirements imposed by GORE-TEX. In fact, silicone-based or similar treatments cannot be used as they may clog the pores of the membrane, which will impair its breathability and will also invalidate your GORE-TEX warranty.