Washing machines require three different types of connection to function. These are electrical, water and waste. If your washing machine is located near your sink, it can be a wise choice to connect the washer to your sink waste. The problem is the splitter is still leaking, its much better, not spraying water out but its still dripping quite a lot. Does anyone have any suggestions as to what I'm doing wrong here? Should I just try tightening it a bit more with pliers? I know washing machine hoses should be hand tightened as over tightening makes them leak but I am very tempted to just to tighten it another few mm, would you advise this or is there a better option? Clamp the saddle assembly in place around the pipe with its two halves square to the pipe, inserting the screws and tightening them fully. Step 4

A drain hose funnels the waste from your washing machine into the ground. So, when fitting a new washing machine, it is a good idea to learn how to install a washing machine drain hose.This doesn’t mean you have admitted defeat, just that you are looking for extra guidance. You may even learn from watching. If you are ready to speak to a professional, please use our handy free search feature to be connected to qualified plumbers in your area. Obviously, neither of these options was going to work for this lazy sod, so I took to searching for a workaround, and I can happily report that I found a few! There are two main ways to connect a dishwasher and washing machine to one waste pipe, one the proper way and the other the lazy mans way. Needless to say, I went the lazy way… can you connect a dishwasher and washing machine to one waste pipe Connecting dishwasher and washing machine to one waste pipe You may need to unscrew the hose from the U-bend under the sink, remembering that this is likely to disconnect your sink waste temporarily too. Consider putting the plug hole stopper in to prevent people from using the sink in the meantime. Yes, I have been running my dishwasher and washing machine off the same waste pipe for over a year now with no problems. It has been used with both machines operating at the same time and again there were no problems. How do you connect a dishwasher to a waste pipe? So I got one from screfix and fitted it as tight as I could with just my hands and straight away it leaked from behind the nut so I used some pliers to tighten it a tiny bit, this seemed to stop the leak so I tried the dishwasher however once it started to draw the water out the water started spraying out. So I tightened it more and more with the pliers and it still wouldn't stop. Eventually I tightened it that much the plastic end broke off.

Washing machines work by pumping in water to use for each wash cycle. After your wash is finished, the wastewater should drain away. However, this doesn’t always happen. In this case, you can either hire a professional to come and remedy the issue or you can learn how to drain a washing machine yourself.It’s not surprising that running waste from your dishwasher and washing machine in the same waste pipe can mean less unsightly pipes leaving your property. This is especially important if they exit via a wall before going into the ground, and can help to eliminate an additional source of leaks should there be an issue at any point. Make sure the valve is in the ‘off’ position, then screw it into the saddle by hand – you’ll feel it cut into the pipe as you do so. Keep turning the valve until its body is at right-angles to the pipe – this will let you turn it on and off easily. Step 5