Once the fish have been purchased and left our premises we will not accept any responsibility for the fish. Securely attach waste pipe to floors, ceilings or walls using a compatible pipe clip or alternatively, direct the waste pipe around bends or corners with a pipe bend at 90°, 92. Join three solvent-weld pipes with a pipe tee and prevent blockages with a solvent-weld access plug. Keep your pipework smooth with our range of solvent weld pipes and connectors, suitable for both domestic and commercial plumbing installations.

solvent weld fittings, but you'll need to cut back, (cant work out if it been painted or not, if it has then you'll need clean the paint off first before trying to glue anything. This must be reported to us within 48 hours and you may be asked to provide proof of the damage before we can arrange a replacement or refund.The PFL range of solvent weld fittings are made from PVC and provide a secure and permanent joint as the application of a solvent paste fuses the two plastic pieces together. The fact is that the actual OD size [as opposed to the nominal size] has changed from 43mm to about 41. Don't know about IKEA sink fitting (I know a lot of their kitchen cabinets etc, can be "odd" sizes -- hopefully that doesn't extend to their plumbing fittings though!

We will not accept any liability for the delays caused by third party contractors waiting for goods to be delivered. This straight connect will receive pipe either end with a stop located in the middle, ensuring both pieces of pipe/fittings joint have the maximum amount of surface contact ensure for a superb watertight seal. It is the perfect choice for anyone who is looking for a high-quality, reliable, and easy-to-use slide valve. My outside waste pipe from the kitchen sink has a 90degree joint that has cracked and causing the waste to leak before reaching the main drain.

Some confusing exists because some makes measure inside and some outside, and some vary slightly in size, for example the push fit stuff is smaller than the solvent weld. Refer to the size chart or check the pipe for markings to identify the type (look for ABS, indicating a solvent pipe). This cannot be used directly onto 56mm waste pipe but must be inserted into a 56mm solvent weld fitting such as a coupling or an elbow.