The vlan command is used to create IEEE 802.1Q VLAN and enter VLAN Configuration Mode. To delete a VLAN, use no vlan command.

Yes. Requiring the use of Omada Cloud-Based Controller (Supported by TL-SG2210P v3.2, v5 and above, while is not supported by TL-SG2210P v4) IGMP Snooping helps the switch maintain a multicast forwarding table by snooping the IGMP transmission between the host and the IGMP Querier. With the forwarding table, the switch can forward multicast data only to the ports that are in the corresponding multicast group, to constrain the flooding of multicast data in the Layer 2 network. The switchport general allowed command is used to add a port to a VLAN and set the tagged/untagged mode. To remove a port for a VLAN, please use no switchport general allowed command. Using Omada controller to configure multiple SSIDs with different VLANs on TP-Link Omada EAPs and Switches to work with a non-Omada gateway(Multi-Net NAT supported) 07-07-2023 17569

Note the Ethernet port type in the command is the native speed mode of the ports, not the current operating mode. For example, assuming the current speed mode of SFP+ port 25 is 1Gbps, to configure it, the command should be “interface ten-gigabitEthernet 1/0/25”, or simply “int te 1/0/25”. Feature Filter: All Configuration Guide User Application Requirement Further Assistance Troubleshooting When You Set Up FAQs Note: Compared with the RJ45 Console cable and USB-to-RS232 cable, it might be more difficult to enter the BootUtil with a Micro-USB cable. If you still cannot enter the BootUtil after several attempts, you may get a USB-to-RS232 cable.

Using the Omada controller to configure multiple SSIDs with different VLANs on TP-Link Omada EAPs and Switches to work with a non-Omada gateway(Multi-Net NAT supported) 06-08-2023 17569 If you only have USB ports on your computer, you can get a USB-to-RS232 cable. You may need to install the RS232 driver for the cable, which is provided by your cable vendor. You can use the Auto-Completion feature to enter a complete command, you can also enter part of the command without completion, and the switch will recognize and execute the command automatically. Do NOT turn off the power during the upgrade process, as it may cause permanent damage to the product. Qual è la differenza tra gli account Master Administrator, Administrator e Viewer in Omada Controller? 04-14-2023 16282How to configure IGMP Snooping for IPTV network on L2 Managed switches using the new GUI 06-27-2022 139402 The question mark not only helps complete the command, but also helps display a list of available commands for each command mode, or a list of relevant keywords and arguments for any command. How to Configure Management VLAN on TP-Link Smart and Managed Switches Using the New GUI 05-18-2023 25766